Gold service
- Carry out initial road test
- Check seat belts operation and mountings
- Fit seat cover and wing bubble wrap
- Check operation of all electrical components
- Check handbrake operation and lever security, adjust and lubricate as needed
- Check battery connection and lubricate
- Check battery attachment
- Check for battery drain
- Change spark plugs
- Check distributor cap, ignition leads and low tension wires for damage
- Inspect coil connections
- Check condition of plug shrouds (if applicable)
- Check connections of engine sensors
- Check drive belts condition, adjust/change if required
- Check security of rocker covers
- Check air cleaner element clean or replace as needed
- Check air induction pipes security
- Check the condition of the engine mounting rubbers
- Check throttles and linkage operation and lubricate
- Check engine breather/hoses for security and condition
- Check/adjust/lubricate all hinges and doors, boot and bonnet locks/catches
- Remove all road wheels
- Clean hubs and apply anti-seize compound
- Inspect brake callipers for leaks
- Inspect discs for wear and cracks
- Inspect flexible hoses for condition
- Remove front & rear brake pads and check for deterioration, wear and cracks
- Change engine oil and filter
- Ensure full purge of old oil in coolers/ dry sump tanks if applicable)
- Check exhaust system
- Check prop shaft bolts
- Replace gearbox oil
- Replace diff oil
- Check condition of steering joints, rack gaiters, ball joints and wishbone bushes
- Check all wheel bearings
- Check for fluid leaks from hydraulic pipes and unions
- Inspect fuel pipes
- Inspect fuel swirl pot
- Replace fuel filter
- Check all suspension fixings for security
- Check anti-roll bar drop link rubbers for wear
- Visually check complete underside of vehicle for faults/abnormalities
- Check security of starter motor wiring connection
- Visually inspect fusable link
- Fully bleed brakes purge all old fluid
- Fully bleed clutch purge all old fluid
- Replace the power steering fluid (where applicable)
- Grease driveshaft uj joints (if applicable)
- Grease prop shaft ujs (if applicable)
- Check & report valve clearances (if applicable)
- Inspect gearbox & diff mounting
- Clean and reset steppa motor
- Visually inspect chassis for corrosion and cracks
- Inspect and advise engine oil leaks
- Check cooling system for leaks, hoses for security
- Replace coolant then check level and anti-freeze concentration
- Set throttle pots
- Check alternator output
- Check lamda operation, wiring and connection
- Check/adjust engine setting on computer with engine at operating temperature
- Check/adjust ignition timing with engine at operating temperature
- Set idle speed
- Balance throttles with air sync (if applicable)
- Check cooling fans operation
- Re seal under bonnet panels (if applicable)
- Torque rear hub nuts
- Check/adjust tyre pressures (inc spare)
- Check tyres for correct spec and damage
- Check road wheels for damage and rotation refit to original position
- Check/adjust tracking front and rear
- Check/adjust cambers front and rear
- Check headlight alignment and auxiliary lights (if fitted)
- Check/top up windscreen washers and check wiper blade condition
- Check window adjustment
- Check door pin wear
- Road test the vehicle
- Clean exterior and interior of vehicle and stamp service book